PIN PAL by Cross Armory

$25.00

  • Front takedown pin replacement – in heavily regulated states AR-15 owners are now opening their receivers with great frequency.  A more durable pin system is needed to prevent undue wear on the forward pivot point – the upper receiver’s take down pin hole
  • Lubricated captive bearing reduces wear – standard steel front takedown pins bear directly on the holes in the aluminum receivers. PIN PAL bears on a lubricant infused bearing
  • Fits any standard ar-15 configuration – easily installs on virtually all AR-15/M4 weapons. The Captive Bearing can be press fit into any upper receiver without special tools
  • Won’t permanently alter your weapon – If you decide to go with a different setup on your weapon, PIN PAL is easily removed and returned to the manufacturer’s factory set-up
  • 4140 ordnance steel – our front takedown pin is machined from 4140 steel with a melonite hard-coating for durability. Our MIL-SPEC Captive Bearing is made from oil-infused, porous metal for reduced friction

The AR-15 was not intended to be opened by the user with great frequency. Increased use translates into increased wear on the upper receiver’s takedown pin hole. Cross Armory’s PIN PAL transfers the rotational wear from a steel pin bearing on the aluminum receiver to a steel pin bearing on a pre-lubricated MIL-SPEC metal bearing, keeping your gun as tight as it was from the factory.

Out of stock

Join Waitlist We will inform you when the product arrives in stock. Please leave your valid email address below.

The Cross Armory PIN PAL is designed to reduce or eliminate that wear that will be caused by the repeated opening and closing of the upper and lower receivers, as now required by so-called assault weapon laws in states like California, New York, New Jersey and other states. The gun manufacturer never intended that the aluminum receivers should be frequently pivoted on a steel front takedown pin. This action will cause accelerated wear on the through-hole in the receiver causing the hole to expand and elongate. Fitment of the upper and lower receivers will become sloppy, making your weapon less dependable. Replacement of an upper receiver is an expensive proposition.

PIN PAL includes a pin, a locking nut and a MIL-SPEC captive bearing. The pin and nut are  machined from 4140 Ordnance Steel for extreme durability. The custom machining of the assembly allows PIN PAL to be built to very tight tolerances.

The MIL-SPEC captive bearing is made from a high density polymer designed to hold tolerance and absorb and rebound in the harshest of conditions. 

PIN PAL is a simple and inexpensive solution to eliminate the wear of a standard steel takedown pin on the softer aluminum upper receiver. It’s bad enough that legal gun owners have to separate their receivers in order to reload. It will be far worse if an upper receiver has to be replaced as a result.

Install Tips –

Do not force it in!

The bearing should press in, but not with excessive force, you should be able to gently tap the bearing/busing in with a rubber hammer.  iF it does not go in easily, sand down the outside with some sandpaper and try again until you get a smooth press fit installation.

The pin should be pre-installed, and slip fit on the bearing.

Email [email protected] with any specific questions or issues.

Happy Hunting!

INSTALLATION if you have a Black PIN PAL Bearing

INSTALLATION if you have a Silver PIN PAL Bearing

Reviews

There are no reviews yet.

Be the first to review “PIN PAL by Cross Armory”